Hole opener

Hole Openers are used to enlarge the diameter of a pre-drilled hole. They are custom built to specification, and come in a wide variety of sizes. A Hole Opener is sometimes referred to as a Reamer.
 
We are proud of the quality and workmanship of our custom built Hole Openers. All Hole Openers can be quoted with new/unused surplus or used Steel Tooth or TCI Cutters Hole Openers.
At some point it may be necessary to increase the size of a pre-drilled hole to a larger diameter or to drill large diameter holes. Hole opener bits are designed specifically for this purpose. Bits are custom manufactured in a wide range of styles to meet field requirements. A custom hole opener is an effective way of enlarging holes, hence the name "Hole Opener".
 
The Hole Opener Advantage
 
Straighter Holes - By drilling a smaller hole with a "pilot" bit, then attaching that said bit onto the bottom of the the hole opener. The hole opener will follow the path of the hole drilled by the smaller bit.
Larger Holes with Smaller Rigs - By drilling a hole in stages, larger holes can be drilled with smaller rigs. A smaller hole requires less power.
Replacing Cutters and Cutting Cost - On most Hole Opener designs, the cutters can be easily replaced. The cost to replace a cutter is a fraction of the cost to replace a large tricone rock bit.
Cost of Large Rock Bits - Larger diameter rock bits not only cost a lot, they can be difficult to find. A more economic solution is to use a hole opener that uses smaller tricone rock bit segments.
Flexibility - Hole Openers can be fabricated in just about any size, and can be configured to drill through any formation.
Operational Considerations
Drilling Weight - The choice of drilling weight is determined based on the recommendations of the bit manufacturer and the number of cutters on the hole opener.
Number of Cutters - The number of cutters placed on a hole opener is governed by the following facts:
◆Maximum number which will fit around the perimeter.
◆The greater the number of cutters, the less the weight, which therefore reduces the penetration rate.
◆In softer formations, less weight is needed to penetrate.
◆The greater the number of cutters, the smoother the tool will run.
◆The greater the number of cutters, the greater the cost.
◆The greater the number of cutters, the longer the cutters will last
Rotary Speed - Maximum speed is determined by the manufacturer's recommendation and the calculation to account for the linear distance the cutter is moving per revolution.
Hole Cleaning - A frequently over looked point of hole opener operation is hole cleaning. The volume of cuttings to remove from a hole increase by a squared factor with an increase in hole diameter.
 
Cutter can be divided into MT type used in soft formation and TCI type used in hard formation. Hole opener takes its advantages in its better teeth distribution,wearing resistance ability, bigger cutting area and higher efficiency.
Size from 12”to 66”
Thread :as your requirement